78
3-20) Setting Machine Head up or Down Function [only for SPS/C-Series]
How to set machine Head up or down function is described below. Vertical control of Head is easy,
because Head of SPS/C-Series is connected with air pressure cylinder. Parameter is originally set not to
raise machine Head after completion of sewing. However, change in setting will raise machine Head after
completion of sewing. This function is available, depending on material and operating environment.
How to set machine Head up or down function:
< < M a i n M e n u > >
1 . P a r a m e t e r S e t
2 . P r o g r a m
3 . B o b b i n W i n d
A. Choose Parameter Set from Main Menu by pushing
.
MODE
C. When choosing,
is set at
.
: After finishing sewing, leave the
Head of machine down.
: After finishing sewing, leave the
Head of machine up.
2)ENABLE
1)DISABLE
1)DISABLE
085. HEAD En/Dis
0 8 5 . H E A D E n / D i s
1 ) D I S A B L E
2 ) E N A B L E
< -
D. To up the Head, move to
, and then
key.
ENTER
2)ENABLE
< P a r a m e t e r S e t >
0 8 5 . H E A D E n / D i s
0 8 6 . R e v A f t e r T r i m
0 8 7 . R e v e r s e A n g l e
B. Choose
from Parameter Set
by using
keys
.
direction
085. HEAD En/Dis
