Chapter 4 – Using the nTier700 VTL BlueScale Web Interface
58
Powering-On the Spectra nTier700 VTL
To power on the nTier700 VTL, press and hold the front panel power button
(Figure 4-1) for two to three seconds or until the button’s LED illuminates. Wait while
the nTier700 VTL completes its power-on sequence, which takes about five minutes,
depending on the nTier700 VTL configuration. During the power-on sequence, the
nTier700 VTL initializes all of its installed components and starts the BlueScale web
server.
Caution:
Do not use the power button to turn off the nTier700 VTL
unless you are specifically instructed to do so by SpectraGuard
Support. Instead, use the shutdown procedure described in this
section.
Figure 4-1
The location of the power button on the front of the
nTier700 VTL
.
Power button
Summary of Contents for Spectra nTier700
