Spectra Logic Spectra nTier700, Installation Manual

Page: 34 / 120

Chapter 2 – Installing the nTier700 VTL
34
2. Lift the front of the shelf and align the lowest hole in the front mounting tabs with
the lowest hole that you want to use on each front post (Figure 2-6). Make sure the
tabs are behind the cut-outs in the posts. Use a level to make sure the front of the
shelf is level.
3.
Using a #2 Phillips screwdriver, install two 10-32 x 1/2-inch SEM screws in the
bottom two holes on each tab to secure the front shelf tabs to the posts. Do not
tighten the screws.
4.
Lift the back of the shelf and adjust the sliders so that they fit against the insides of
the rear posts.
5.
Align the lowest hole in each of the rear mounting tabs so that the shelf is level,
both from front to back and side to side. Using a #2 Phillips screwdriver, install
three 10-32 x 1/2-inch SEM screws in each tab to secure the shelf to the post.
Tighten all 12 screws to secure the shelf assembly to the rack posts.
Note:
Make sure that the two sides of the shelf are attached to the rack at
the same height on all four posts. Use a level to ensure that the
shelf is level from side to side and front to back.
Figure 2-6 Position the shelf in the rack.
Screws in front shelf tabs
Front of rack
Adjustable sliders
Back of rack