Spectra Logic Spectra nTier700, Installation Manual

Page: 39 / 120

Installing Data Drives in the Blades
39
5. Release the latch on the drive sled by pushing the locking tab to the left, then
pulling the latch slightly toward the top of the drive to open it (see Figure 2-10 and
Figure 2-11).
Note:
You only need to pull up on the latch enough to release it.
6.
Position the drive sled over a drive slot in the blade with the latch toward the center
of the blade and the edges aligned with the guides in the drive slot (Figure 2-11).
7. Slide the drive sled into the drive slot and press down firmly until an audible click
indicates that the drive sled is seated.
If the drive sled latch does not automatically latch when you seat the drive, press
down firmly on the latch until you hear the click.
Figure 2-10 Release the drive sled latch.
Figure 2-11 Align the drive sled with the drive slot.
Tab