Sony RM-NX7000 Navitus, Operating Instructions Manual

Page: 47 / 252

47
Basic Oper
ations
■
When two or more preset codes are detected
The display on the right appears.
Program a preset code by performing
one of the following ways.
z
Tip
If you press the [CANCEL] key, the preset
code will not be programmed and the display
will return to the programming method
selection display (step 1 on page 45).
◆
To reduce the number of expected codes by transmitting a
signal again.
1 Press the [CONTINUE] key.
The display returns to step 2 and the instruction in the display asks
you to press a different button. Repeat this step until a preset code
appears in the display.
◆
To select a preset code from the list of preset codes
1 Press the [LIST] key.
The list of preset codes appears and expected preset codes are
displayed in red.
2 Press the [ v ] or [ V ] key to select
the preset code to be programmed,
and then press the [OK] key.
The selected preset code is
programmed for the Remote
Commander, and the display returns
to the component selection display
(step 3 on page 43).
z
Tips
• Each time you press the [ v ] or [ V ] key, the cursor moves one line up or down
on the list. If you press the [ v ] or [ V ] key for 2 seconds or longer, the list in the
display scrolls.
• If you press the [CANCEL] key, the preset code will not be programmed and
the display will return to the previous one.
4 To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.