Sony RM-NX7000 Navitus, Operating Instructions Manual

Page: 49 / 252

49
Basic Oper
ations
■
When the component to be registered does not function properly
The selected preset code may be incorrect. Select again the preset code by
pressing the [
v ] or [ V ] key, aim the Remote Commander at the component
to be registered, and then press the [TEST] key again.
z
Tips
• Each time you press the [ v ] or [ V ] key, the cursor moves one line up or down on
the list. If you press the [ v ] or [ V ] key for 2 seconds or longer, the list in the display
scrolls.
• The name of the test key signal is displayed on the left of the [TEST] key. Each time
you press the [TEST] key, the test key signal assigned to the preset code selected by
the cursor is automatically changed. The test key signal names assigned to the
selected preset code will cycle automatically.
4 Press the [OK] key.
The preset code is programmed for the Remote Commander and the
display returns to the component selection display (step 3 on page 43).
z
Tip
If you press the [CANCEL] key, the preset code will not be programmed and the
display will return to step 1 on page 48.
5 To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.