Sony DVS-9000, User Manual

Page: 796 / 1228

Chap
te
r
1
4
Sn
aps
ho
ts
796
Snapshot Operations in the Flexi Pad Control Block
Not lit: register not containing anything
4
To apply an attribute, hold down the [SNAPSHOT] button, and in the
memory recall section, press a button as follows, turning it on.
For details of attributes, see “Snapshot Attributes” (page 785).
Note
In the Flexi Pad control block, it is not possible to apply the cross-point
hold or GPI output attributes. In a simple type Flexi Pad control block, it
is not possible to apply any attributes. To add these attributes, use a menu
operation.
(See page 806.)
5
Still holding down the [SNAPSHOT] button from step 4 , press the
memory recall button corresponding to the register in which you want to
save.
Recalling a snapshot in the Flexi Pad control block (standard
type or simple type)
Note
When an M/E bank is not assigned to any region selection button in the
numeric keypad control block in a setup setting, it is not possible to recall a
snapshot with the Flexi Pad control block of that M/E bank.
(See “Assigning a
Region to a Region Selection Button in the Numeric Keypad Control Block” in
Chapter 19 (Volume 3).)
As an example, to recall a snapshot on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the register
number last recalled on the bank.
2
Select the bank for recall.
See step 3 (page 795) in “Saving a snapshot in the Multifunction Flexi Pad
control block.”
Attribute to apply Button
Effect dissolve [EFF DISS] button
Auto transition [AUTO TRANS] button