Sony DVS-9000, User Manual

Page: 148 / 1228

148
Signal Selection
Chapt
er
3
S
ign
al Sele
c
tio
n
a
nd T
ran
s
itio
n
s
Auxiliary bus control block button numbers ([2ND] button lit)
Inhibiting cross-point button operations
For each cross-point button, you can temporarily inhibit operations.
Note
This setting is cleared when you reset the control panel.
Assigning a button to the function of disabling cross-point button
operation
You can assign the button to be used for the operation to the [PRE MCRO]
button, in setup.
(See “Overall Control Panel Settings (Config Menu)” in
Chapter 19 (Volume 3).)
You can also use the [Inhibit Set] and [Inhibit All Clear] functions, assigned to
user preference buttons.
(See “Setting Button Assignments (Prefs/Utility
Menu)” in Chapter 19 (Volume 3).)
Buses for which operations can be inhibited
This setting applies to the auxiliary bus control block (when using the CCP-
8000) and the cross-point buttons in each switcher bank. However, when using
the CCP-6224/6324, buses may be assigned with the cross-point button rows
for keys 1 and 2 as the auxiliary bus control block.
For example, if you make the setting for one cross-point button in a switcher
bank, this inhibits operation of all cross-point buttons with the same number in
the following buses.
The corresponding name also disappears from the source name display.
• Background A, background B
• Keys 1 to 4
• Utility 1, Utility 2
• DME utility 1, DME utility 2
• External DME
To inhibit operation of a cross-point button
Hold down the button which “Inhibit Set” is assigned, and press the cross-point
button whose operation you want to inhibit.
The button you pressed flashes amber, and this makes the operation inhibited.
Button Number when the shift
button is not pressed Number when the shift
button is pressed
From the left end to the 31st
button 1 to 31 32 to 62
Reentry buttons 121 to 124 125 to 128