Soehnle Professional 3035, Manual

Page: 94 / 124

94
Selection options for displaying the total
Clearing the totalizing memory
The following functions can be assigned to the Total function key in Setting mode:
> Display, print and delete totalsAfter
pressing the Total function key, the totals are displayed for 3 seconds, the contents of the memory
are printed and deleted at the same time. You can then start a new totalizing procedure.
> Display totals onlyAfter
pressing the Total function key, the user can decide whether to clear the totalizing memory.
Press the F2 Clear total key to delete the total memory.
If you want to continue totalizing without deleting the memory, press the F6 Back key.
Relief factor for summation
(Cannot be activated during picking)
In setting mode, you can specify that the scale must be unloaded by a certain number of digits between the
placement of each item on the scale
. This prevents, for example, double storage of an item.
Auto-Summing
In setting mode, the Auto Sum function can be activated.
Then only the first position has to be taken over with the plus key, all further positions are automatically
loaded according to weight and stability are stored in the totalizing memory.
As long as Auto-Summing is active, the plus key is dimmed.
If the auto-summing is interrupted by cancellation, error message or change of measuring point,
then Auto-Summing must be started again with the Plus key.
Info: Auto-summing can be defined as a print triggering condition just like manual summing
(see chapter 8 Printing).
Assigning and deleting the sequence number
Each entry (plus, hand, cancellation) in the totalizing memory increases a four-digit consecutive number.
The sequence number is not reset in the factory setting.
Optionally, you can specify in setting mode to reset the sequence number:
> not active (no reset = factory setting)
> with key Delete total
> when switching off
> Function key "delete current number