Snap-On Sun SWB 340, Operator'S Manual

Page: 82 / 152

82
5-33
5-34
5-35
5-36
20
21
28
26
26
Operation
5.11.3 Start optimisation/weight
minimisation
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions and check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 20
Optimisation – Minimisation ( Fig. 5-33 ).
The OPTIMISATION MENU “OP.1” screen is displayed
( Fig. 5-34 ).
If an optimisation/minimisation result has already
been saved, press the key
21 ( Fig. 5-35 ); in this way,
the program continues from the step where it was
interrupted, with the relative measurement values
and settings, and the optimisation/minimisation may
continue.
At this point, you can choose whether to continue
Optimisation (Key
26 ), or go to Minimisation (Key 28 ).
5.11.3.1 OPTIMISATION
—
Clamp the rim only.
— Move the gauge into position on the rim, based on
the desired ALU.
— Perform a measuring run.
— In the BALANCING menu press key 20 ( Fig. 5-33 ).
The “OP.1” screen page appears ( Fig. 5-34 ).
— Press the menu key 26 ( Fig. 5-34 ).
The OPTIMISATION “OP.2” screen is displayed ( Fig.
5-36 ).