104
6-3
6-2
1
1b
26
6-1
4
7c
Maintenance
6.0 Maintenance
This unit is designed to operate for a long time.
If the operator shuts down the unit correctly (
F
5.2.4)
at the end of each shift, no further maintenance is
required.
This unit must not be opened by the operator.
6.1
Compensation Run
All clamping and centring means are balanced within
a maximum permitted tolerance.
To compensate for any residual unbalance that might
be left in the clamping tool, it is recommended that a
compensation run be performed after switching on
the machine or after changing the wheel adaptor,
especially a motorcycle wheel adaptor. This mode
cannot be transferred into the permanent memory.
Application
:
—
Fit the clamping device properly on the balancer
shaft. Do not fi t the wheel.
—
From the MAIN MENU select:
-
SETTINGS
(
4
).
-
COMPENSATION (
7c
,
Fig. 6-1
).
The COMPENSATION screen
C4
(
Figure 6-2
) is
displayed.
—
Start the compensation run using the
START
key
(
1b
).
The Compensation Run takes longer than a regular
measuring run. After the run, an icon in the Status Bar
indicates the Compensation Active status (
1, Fig. 6-3
).
Compensation remains active until cancelled by one
of the following cases:
- Selection of confi rmation with
OFF
key (
26
)
- after a recalibration,
- after an optimisation run or
- by switching off the machine.
Summary of Contents for Sun SWB 340
Page 142: ...142 Blank Page...
