146
ii-1
ii-2
Installation
ii Transport, unpacking and contents
Carriage instructions
The wheel balancer is supplied on a pallet.
•
Use a pallet truck (
Figure ii-1
) to bring the unit to
its working area.
Unpacking
WARNING: PREVENT THE STRAPS FROM
SPRINGING LOOSE AFTER BEING CUT.
•
Cut the straps.
•
Open the top of the box.
•
Remove staples at the bottom of the box. Lift the
box up and over the unit.
•
Carefully unwrap the balancer and spare parts
supplied.
•
Check the content of the shipment.
Contents
The shipment contains:
- a wheel balancer.
- an Operator’s Manual with Declaration of Conformity
(CE).
- the accessories mentioned in Section 3.1 of the
Operator’s Manual.
- 3 threaded pins with accessory support plate.
- a power cable.
- a wheel guard.
Tools required
- screwdriver / bar (diameter 4.5-5 mm)
- wrench: 13 mm
- wrench: 17 mm
- Allen wrench: 5 mm
Positioning
•
Remove the bolts that secure the wheel balancer
on the pallet.
WARNING:
DO NOT LIFT OR MOVE THE WHEEL BALANCER
BY THE MAIN SHAFT OR MEASURING UNIT
.
•
Refer to
Figure ii-2
. Move the wheel balancer from
the pallet to its working location.
Note:
To handle the unit, preferably use the
accessory support pins (mount as
instructed in
section
iii) and/or the wheel
guard shaft (if present).
Summary of Contents for Sun SWB 340
Page 142: ...142 Blank Page...
