Command Line Interface
4-184
4
Example
The following shows how to configure the query interval to 100 seconds.
ip igmp snooping query-max-response-time
This command configures the query report delay. Use the
no
form to restore the
default.
Syntax
ip igmp snooping query-max-response-time
seconds
no ip igmp snooping query-max-response-time
seconds
- The report delay advertised in IGMP queries. (Range: 5-25)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• This command defines the time after a query, during which a response is
expected from a multicast client. If a querier has sent a number of queries
defined by the
ip igmp snooping query-count
, but a client has not
responded, a countdown timer is started using an initial value set by this
command. If the countdown finishes, and the client still has not responded,
then that client is considered to have left the multicast group.
Example
The following shows how to configure the maximum response time to 20 seconds.
Related Commands
ip igmp snooping version (4-179)
ip igmp snooping query-max-response-time (4-184)
Console(config)#ip igmp snooping query-interval 100
Console(config)#
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#
Summary of Contents for 8124PL2
