SMC Networks 8124PL2, Management Manual

Page: 119 / 491

Configuring the Switch
3-74
Web – Specify the action (i.e., Permit or Deny). Select the address type (Any, Host,
or IP). If you select “Host,” enter a specific address. If you select “IP,” enter a subnet
address and the mask for an address range. Then click Add.
Figure 3-44. Configuring Standard IP ACLs
CLI – This example configures one permit rule for the specific address 10.1.1.21
and another rule for the address range 168.92.16.x – 168.92.31.x using a bitmask.
Configuring an Extended IP ACL
Command Attributes
• Action – An ACL can contain either all permit rules or all deny rules.
(Default: Permit rules)
• Src/Dst Address Type – Specifies the source or destination IP address. Use
“Any” to include all possible addresses, “Host” to specify a specific host address in
the Address field, or “IP” to specify a range of addresses with the Address and
SubMask fields. (Options: Any, Host, IP; Default: Any)
• Src/Dst IP Address – Source or destination IP address.
• Src/Dst Subnet Mask – Subnet mask for source or destination address. (See the
description for SubMask on page 3-73.)
• Service Type – Packet priority settings based on the following criteria:
• Precedence – IP precedence level. (Range: 0-7)
• TOS – Type of Service level. (Range: 0-15)
• DSCP – DSCP priority level. (Range: 0-64)
Console(config-std-acl)#permit host 10.1.1.21 4-90
Console(config-std-acl)#permit 168.92.16.0 255.255.240.0
Console(config-std-acl)#