SMC Networks 8124PL2, Management Manual

Page: 125 / 491

Configuring the Switch
3-80
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the
switch will not accept overlapping address ranges. When entering addresses for
different groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete
the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
Command Attributes
• Web IP Filter – Configures IP address(es) for the web group.
• SNMP IP Filter – Configures IP address(es) for the SNMP group.
• Telnet IP Filter – Configures IP address(es) for the Telnet group.
• IP Filter List – IP address which are allowed management access to this interface.
• Start IP Address – A single IP address, or the starting address of a range.
• End IP Address – The end address of a range.
• Add/Remove Filtering Entry – Adds/removes an IP address from the list.
Web – Click Security, IP Filter. Enter the addresses that are allowed management
access to an interface, and click Add IP Filtering Entry.
Figure 3-48. Filtering Management Access
CLI – This example restricts management access for Telnet clients.
Console(config)#management telnet-client 192.168.1.19 4-27
Console(config)#management telnet-client 192.168.1.25 192.168.1.30
Console#