SMC Networks 8124PL2, Management Manual

Page: 318 / 491

Authentication Commands
4-85
4
Example
show dot1x
This command shows general port authentication related settings on the switch or a
specific interface.
Syntax
show dot1x [ statistics ] [ interface interface ]
- statistics - Displays dot1x status for each port.
- interface
-
ethernet unit / port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-28)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
- Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the switch.
- 802.1X Port Summary – Displays the port access control parameters for
each interface that has enabled 802.1X, including the following items:
- Status– Administrative state for port access control.
- Operation Mode–Allows single or multiple hosts (page 4-82).
- Mode– Dot1x port control mode (page 4-81).
- Authorized– Authorization status (yes or n/a - not authorized).
- 802.1X Port Details – Displays the port access control parameters for each
interface, including the following items:
- reauth-enabled – Periodic re-authentication (page 4-83).
- reauth-period – Time after which a connected client must be
re-authenticated (page 4-84).
- quiet-period – Time a port waits after Max Request Count is exceeded
before attempting to acquire a new client (page 4-83).
- tx-period – Time a port waits during authentication session before
re-transmitting EAP packet (page 4-84).
- supplicant-timeout – Supplicant timeout.
- server-timeout – Server timeout.
- reauth-max – Maximum number of reauthentication attempts.
- max-req – Maximum number of times a port will retransmit an EAP
request/identity packet to the client before it times out the
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#