SMC Networks 8124PL2, Management Manual

Page: 186 / 491

LLDP
3-141
• Delay Interval - Configures a delay time between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. (Range: 0-8192
seconds)
• Reinitialisation Delay - Configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down. (Range: 0-10 seconds)
• Notification Interval - Configures the allowed interval for sending SNMP
notifications about LLDP changes. (Range: 0-3600)
Web – Click LLDP, Configuration.
Figure 3-86. LLDP Configuration
CLI – This example shows the setting of the transmit interval to 60 seconds, the
transmit delay to 10 seconds, the hold time to 10 seconds, the reinitialisation delay
to 10 seconds, and the notifcation interval to 30 seconds.
Configuring LLDP Port and Trunk Information
These commands enable LLDP transmit, receive, or transmit and receive mode on
the specified port, whether to send SNMP notifications, and sets the TLV type.
Command Attributes
• Port - Specifies the port number.
• LLDP - Enables LLDP transmit (Tx only), receive (Rx only), or transmit and receive
RxTx) mode on the specified port. Chosing ‘Disabled’ disables LLDP on the port.
• SNMP Notification - Enables the sending of SNMP trap messages about LLDP
changes on the specified port.
• TLV Type - Configures the port to advertise the management address for the
deivce, the port description, the system capabilities, the system description and the
system name. Check each respective box to enable each feature.
Console(config)#lldp transmit- interval 60 4-201
Console(config)#lldp transmit-delay 10 4-201
Console(config)#lldp transmit-hold 10 4-202
Console(config)#lldp reinit-delay 10 4-202
Console(config)#lldp notification-interval 30 4-203
Console(config)#