![background image](http://html.mh-extra.com/html/smc-networks/8124pl2/8124pl2_management-manual_1300682450.webp)
UPnP
4-217
4
upnp device
This command enables UPnP on the device. Use the
no
form to disable UPnP.
Syntax
[
no
]
upnp device
}
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
You must enable UPnP before you can configure time out settings for sending of
UPnP messages.
Example
In the following example, UPnP is enabled on the device.
Related Commands
upnp device ttl (4-217)
upnp device advertise duration (4-218)
upnp device ttl
This command sets the time-to-live (ttl) value for receiving of UPnP messages on
the device.
Syntax
upnp device ttl
{
value
}
•
value
- A time out value expressed in seconds. (Range: 1-255 seconds)
Default Setting
4 seconds
Command Mode
Global Configuration
Command Usage
You must set the ttl value before the device can listen for UPnP messages. After the
ttl has expired, the device will listen again for new UPnP information.
Console(config)#upnp device
Console(config)#
Summary of Contents for 8124PL2
