Command Line Interface
4-122
4
Default Setting
Enabled
Command Mode
Interface Configuration
Example
The following shows how to disable broadcast storm control on an interface:
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target port.
port monitor
This command configures a mirror session. Use the
no
form to clear a mirror
session.
Syntax
port monitor interface
[
rx
|
tx
|
both
]
no port monitor
interface
•
interface
-
ethernet
unit
/
port
(source port)
-
unit
- Stack unit. (Always unit 1)
-
port
- Port number. (Range: 1-28)
•
rx
- Mirror received packets.
•
tx
- Mirror transmitted packets.
•
both
- Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is for both
received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Console(config-if)#no switchport broadcast
Table 4-45. Mirror Port Commands
Command
Function
Mode
Page
port monitor
Configures a mirror session
IC
4-122
show port monitor
Shows the configuration for a mirror port
PE
4-123
Summary of Contents for 8124PL2
