SMART Embedded Computing 6806800V18A, Installation And Use Manual

Page: 154 / 164

152 AXP1440-C07 Installation and Use (6806800V18A)
Shelf Management Module
Shelf Management Module
The default configuration of Ethernet channels is depicted in
Table 7-9
and
Table 7-10
.
7.4.2.4 Configuring Front Panel Network Interface
To set front panel Ethernet and make it permanent over power cycle set the following U-
boot environment variables. This may be done in Linux or U-Boot. If done in U-Boot
saveenv
must be executed to save the environment variables.
setenv ip1addr <IP address>
setenv gatewayip <gateway IP>
setenv enable_front_panel_ethernet y
saveenv
7.4.2.5 Configuring the RMCP Network Interface
To change the Remote Management Control Protocol (RMCP) network address that is
associated with the Active and Standby Shelf managers from the default values, use the
clia
command on the Active shelf manager, where
xxx.xxx.xxx.xxx
indicates a sample
IP address.
clia setlanconfig 1 3 xxx.xxx.xxx.xxx
Table 7-9 Shelf Manager Static Network IP Interfaces
Function IP SAM-A IP SAM-B
Ethernet
Device
Default State
SAM - SAM 192.168.25.101 192.168.25.100 ETH0 Enabled
Front Panel RJ-45 0.0.0.0 0.0.0.0 ETH1 Disabled
SAM to Hub 192.168.24.101 192.168.24.100 ETH1.24 Enabled
Table 7-10 Shelf Manager Dynamic Network IP Interfaces
Function IP Active SAM
IP Backup
SAM Ethernet
Device
Default State
Dynamic/RMCP 192.168.24.11 192.168.24.10 ETH1.24:1 Enabled
NOTICE
The IP addresses defined in
Table 7-10
are relative to active/backup SAM. When
active/backup switchover takes place, the addresses are reassigned to the
appropriate physical SAMs.