SMART Embedded Computing 6806800V18A, Installation And Use Manual

Page: 20 / 164

18 AXP1440-C07 Installation and Use (6806800V18A)
Safety Notes
Safety Notes
The product conducts, radiates and uses radio frequency energy and, if not installed
properly and used in accordance with this user documentation, may cause harmful
interference to radio communications.
Changes or modifications not expressly approved by SMART EC could void the user's
regulatory compliance. Board products are tested in a representative system to show
compliance with the above mentioned requirements. A proper installation in a compliant
system will maintain the required performance.
Use only shielded cables when connecting peripherals to help assure that appropriate radio
frequency emissions compliance is maintained. For proper EMC shielding, only operate the
system with face plates installed and all vacant slots covered or populated with filler cards.
An AXP1440 that is shipped as a spare, replacement chassis, or an unconfigured system
will not have filler panels installed. It is the responsibility of the customer to ensure that all
open slots are filled with payload blades, rear transition modules (RTMs), or approved filler
panels in order to be compliant with the safety/EMC regulatory markings.
This is a Class A product based on the standard of the Voluntary Control Council for
Interference (VCCI) by Information Technology Interference. If this equipment is used in a
domestic environment, radio disturbance may arise. When such trouble occurs, the user
may be required to take corrective actions.
The equipment is suitable for installation in a Common Bonding Network (CBN) or Isolated
Bonding Network (IBN).
Grounding
If the product is not properly grounded, it may be damaged by electrostatic discharge.
The system contains EMI gaskets at the shelf and module level. Make sure that each of the
system's parts contact the EMI gasket.
The shelf is also fitted with an ESD jack/snap for use with conductive wrist straps. Make
sure the operator uses proper ESD protection.
System Installation
System Damage
To avoid system damage verify that the system environment meets the environmental and
power requirements given in this manual before installing the system. Before you set up
and cable your new system, consider these guidelines:

Restricted access location: Intended for installation in a restricted access location
with access by trained personnel only.