SMART Embedded Computing 6806800V18A, Installation And Use Manual

Page: 122 / 164

120 AXP1440-C07 Installation and Use (6806800V18A)
FRU Installation
FRU Installation
2. Slide the latch into the release position and pull out the handle outward to unlatch the
handle from the face plate. Do not pull the handle fully outward.
3. Insert blade into the shelf by placing the top and bottom edges of the blade in the card
guides of the shelf. Make sure that the guiding module of shelf and blade are aligned
properly.
4. Apply equal and steady pressure to the blade to carefully slide the blade into the shelf
until you feel resistance. Continue to gently push the blade until the blade connectors
engage.
5. Fully insert the blade and push the upper and lower handles towards the face plate.
The latch automatically slides inwards and lock the handles
If your shelf is powered, as soon as the blade is connected to the backplane power
pins, the blue LED is illuminated.
When the blade is completely installed, the blue LED starts to blink. This indicates
that the blade has announced its presence to the shelf management controller.
6. Wait until the blue LED is switched off, then tighten the face plate screws which secure
the blade to the shelf.
When the blue LED is switched OFF and the green IS (In Service) LED is switched
ON, this indicates that the payload has been powered up and that the blade is
active.
7. Tighten the two handle screws.
Latch
Handle
Latch Release
Latch Lock
If you feel that you need an abnormal amount of force during blade insertion to insert
the blade into the slot, extract the blade and carefully inspect the blade and slot for
problems to prevent damage.