14/88
Siemens Synco
900
CE1C2707en
Building Technologies
Commissioning the system
05.07.2007
Commissioning the system
Prerequisites
Prior to commissioning the system, check to ensure that the following
prerequisites are met:
•
You are familiar with the different operating elements and
operating levels of the central apartment unit.
•
All system components are correctly installed.
•
Mains-powered components are connected to power.
•
New batteries are readily available to be inserted in the
battery-powered devices *.
•
Wire-bound devices are connected to the KNX TP1 data bus.
* To extend battery life, insert the batteries only just before
connecting the device to the central apartment unit (for
procedure, refer to the Mounting Instructions of the relevant
device).
Procedure
The system should be commissioned in steps:
1. Make the basic configuration of the central apartment unit.
2. Switch on and connect the devices communicating via radio
(KNX RF).
3. Make the wiring test.
4. Configure the wire-bound bus communication (KNX TP1).
5. Set the parameters of the central apartment unit.
Basic configuration of the central
apartment unit
To connect the devices, the basic configuration of the central apart-
ment unit must be made first.
Switch on the central apartment unit
To be able to make the basic configuration of the central apartment
unit, it must be switched on.
The unit is switched as soon as
power is applied to it. During the
period of time the hour glass is
displayed, a short function test is
made.
Summary of Contents for Synco 900
