Siemens Synco 900, Mounting And Commissioning

Page: 54 / 88

54/88
Siemens Synco 900 CE1C2707en
Building Technologies Commissioning the system 05.07.2007
Connect Hager tebis devices
Hager tebis light and blind actuators can only be assigned to
switching groups or lights which, beforehand, were set up for
the respective function (refer to ”Configure the switching
groups“ on page 21 and “Configure light status indication“ on
page 25).
The light and blind actuators are switched on as soon as power is
applied to them.
Hager tebis devices are commissioned and connected to the central
apartment unit with the help of the TX100 configurator supplied by
Hager. To be able to make connections to Hager tebis products, or to
remove them, select the following menu on the central apartment unit:
Main menu > Commissioning > RF connections > Hager Tebis
This menu must always be used when working with the TX100
configurator. Quit the "Hager tebis" menu only when configu-
ration with the TX100 is completed. If you leave the "Hager
tebis" menu while working with the TX100 configurator and you
select it again, the configurator’s operating mode must briefly
be switched to "Auto" and then back to "Prog".
Number inputs
From the configurator’s perspective, switching groups are inputs. To
make the configurator familiar with these inputs and to assign a num-
ber, select the respective switching group on the central apartment
unit and press the
Menu/ok button:
Main menu > Commissioning > RF connections > Hager Tebis >
Switching groups > Switching group X
Successful dispatch of the respective telegrams is displayed for a
short moment on the central apartment unit.
For detailed information on commissioning Hager tebis com-
ponents, refer to the documentation covering Hager tebis
products.