Siemens Synco 900, Mounting And Commissioning

Page: 63 / 88

63/88
Siemens Synco 900 CE1C2707en
Building Technologies Commissioning the system 05.07.2007
common usage. The DHW heating system that should use this time
switch should be set to “Slave“.
In the case of ”Time switch operation = Slave”, the following opera-
ting line should be used to set the DHW zone of the time switch
master (1..31):
Main menu > Commissioning > Bus communication > DHW >
Time swi slave DHW:
Factory setting 1
Your setting
Set the distribution zone
The system’s devices exchange the data on the bus within their dis-
tribution zone. A heat source in heat distribution zone 1, for example,
receives the heat demand signals from heat distribution zone 1.
Set the outside temperature zone (1..31) and the heat distribution
zone (1..31) where the central apartment unit is located.
When using setting "---", no data of the respective distribution
zone is sent or received via bus.
Main menu > Commissioning > Bus communication >
Distribution zones > Outside temp zone:
Main menu > Commissioning > Bus communication >
Distribution zones > Heat distr zone:
Distribution zone Factory setting Your setting
Outside temperature and
atmospheric pressure zone ---
Heat distribution zone 1
The zone settings must be unambiguous. For example, only
one outside sensor may have outside temperature zone 1
assigned.
Quitting the “Commissioning“ menu
On completion of commissioning, press the
Esc button to quit the
“Commissioning” menu. The plant is still out of operation.
When you confirm this message
by pressing the
Menu/ok button,
the plant is put into operation
according to the new settings and
the display returns to the ”Main
menu”.
Caution!
Plant starts