80/88
Siemens Synco
900
CE1C2707en
Building Technologies
Communication
05.07.2007
Communication
Protocol
Konnex (RF and / or wire-bound)
KNX TP1
2-wire bus conforming to KNX TP1,
plus RJ45 jack for connection of service tool
KNX RF
RF bus conforming to KNX RF
Maintenance / service
Peripheral devices
Restore factory settings
To restore the factory settings of the peripheral devices, press the
multifunction button on the device for at least 20 seconds.
Then, a restart is made. Now, the factory settings are restored and
the device is no longer connected to the central apartment unit.
Manual control of the radiator control actuator
For service work, or in the event
of fault, the SSA955 can be
brought into any position using a
3 mm hexagon socket wrench.
-
+
27
00
Z
06
-
+
3 mm
Disposal
The central apartment unit and the various partner devices
must be disposed of as electronic scrap in compliance with
the European directive 2002/96/EEC (WEEE), and not to-
gether with municipal waste. The relevant national regulations
must be observed using the correct disposal channels. Local
and currently valid legislation must be complied with. Ex-
hausted batteries must be disposed of in compliance with the
relevant environmental regulations.
Summary of Contents for Synco 900
