Diagnosis / Faults and Alarms
11/03
SINAMICS G150
10-4
Operating Manual
10.2.2
Diagnosis via Parameters
Diagnostic Parameters for the Device Status
r0002
Drive status
Display of drive status.
r0046
Missing enable signals
Display of the missing enable signals.
Bit 00: Enable OFF1
0: present
1: missing
Bit 01: Enable OFF2
0: present
1: missing
Bit 02: Enable OFF3
0: present
1: missing
Bit 03: Operation enabled
0: present
1: missing
Bit 08: Enable SH
0: present
1: missing
Bit 09: Enable infeed
0: present
1: missing
Bit 10: Enable ramp generator
0: present
1: missing
Bit 11: Ramp generator start
0: present
1: missing
Bit 12: Enable setpoint
0: present
1: missing
Bit 17: Int. enable OFF2
0: present
1: missing
Bit 18: Int. enable OFF3
0: present
1: missing
Bit 21: Int. enable STOP2
0: present
1: missing
Bit 27: Demagnetization
0: complete
1: not complete
Value 0 indicates that all the enable signals for this drive are present.
Bit 00 = 1 (no enable) when:
The signal source in p0840 is set to 0 signal.
Power-on disable is present.
Bit 01 = 1 (no enable) when:
The signal source in p0844 or p0845 is set to 0 signal.
Bit 02 = 1 (no enable) when:
The signal source in p0848 or p0849 is set to 0 signal.
Bit 03 = 1 (no enable) when:
The signal source in p0852 is set to 0 signal.
Bit 08 = 1 (no enable) when:
No pulse enable on the motor module (X21.3, X21.4)
Bit 09 = 1 (no enable) when:
The signal source in p0864 is set to 0 signal.
Bit 10 = 1 (no enable) when:
The signal source in p1140 is set to 0 signal.
Bit 11 = 1 (no enable) when:
The signal source in p1141 is set to 0 signal.
Bit 12 = 1 (no enable) when:
The signal source in p1142 is set to 0 signal.
Bit 17 = 1 (no enable) when:
Commissioning mode is set (p0009 > 0 or p0010 > 0).
Bit 18 = 1 (no enable) when:
OFF3 or fault reaction OFF3 is not yet complete.
The bit is reset with the power-on disable function.
Bit 21 = 1 (no enable) when:
The holding brake is applied or has not yet been released.
The motor is not yet magnetized.
Bit 27 = 1 (no enable) when:
Demagnetization is not yet complete.
Summary of Contents for SINAMICS G150
