Siemens SIMOTICS T-1FW68, Configuration Manual

Page: 114 / 194

Configuring
5.2 Mounting
1FW68 radial segment motors
112
Configuration Manual, 08/2021, A5E51132930B AA
5. Tighten the fixing screws on the left-hand T-sliding block. However, leave the fixing
screws on the right-hand T-sliding block loose.
Note
Tighten the fixing screws of the T-sliding blocks.
Always push the rotor segments in the opposite direction to the chosen fitting
direction as far as they will go against the T-sliding block before you tighten the
screws of this T-sliding block.
6. Then slide the second rotor segment between the T-sliding blocks directly to the right
of the first rotor segment and up to the mechanical stop.
7. Loosen the screws of the adjacent T-sliding block on the right so much that the second
rotor segment is pulled to the first rotor segment by the magnetic attraction force.
Assist this movement with the hand if necessary.
8. Tighten the fixing screws on the left-hand T-sliding block. However, leave the fixing
screws on the right-hand T-sliding block loose.
9. Repeat the steps described above with the other rotor segments up to and including the
last but one.