![background image](http://html.mh-extra.com/html/sick/tdc-b100/tdc-b100_operating-instructions-manual_1264311037.webp)
ELECTRICAL INSTALLATION
5
37
8021804/2017-11-27|SICK
Subject to change without notice
T R A N S L A T I O N O F T H E O R I G I N A L I N S T R U C T I O N S | Telematic Data Collector
Connecting the TDC-M100 to a SICK sensor
Fig. 25: Connecting the TDC-M100 to SICK sensors
1. Connect the two wires of the connecting cable for the TDC device to two digital inputs.
If you use the I/O connections, you must ensure that they have been configured as
inputs.
2. Connect one wire of the connecting cable for the TDC device to the
DOUT CAN1
or
DOUT RS485
input. Voltage will then be supplied to the sensor.
3. Connect the wires to the connecting cable of the sensor via an adapter.
Pin
Connection
9/10
11/12
Configured as digital inputs for signal transmission
5/1
Voltage supply output for connected sensors
Tab. 17: Connecting the TDC-M100 to SICK sensors
The yellow and white wires of the connecting cable for the voltage supply can also
be used for signal transmission for one sensor. In addition, the sensor needs to be
connected to an output for the voltage supply as described.
Pin
Connection
15
IN-E digital input
16
IN-F digital input
5/1
Voltage supply output for connected sensors
Tab. 18: Connecting the TDC-M100 to one SICK sensor via the cable for the voltage supply
Note
Note