Segway SE-3 Patroller, Service Manual

Page: 95 / 148

Service Manual
87
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Install the O-ring on the input side of the Gearbox.
See Figure 116 .
3. Orient the Gearbox on the Frame so that the Gearbox
is tipped toward the rear of the SE-3 Patroller.
4. Slide the Gearbox into place, making sure the plastic
coupling fits over the Elastomer Bushing.
5. Using an 8 mm hex wrench, install the three Gearbox
fasteners. See Figure 115 .
Torque to 67 N-m (49 ft-lbf) .
6. Using a 6 mm hex wrench, install the Caliper Bracket.
See Figure 117 . Torque to 28.5 N-m (21.0 ft-lbf) .
7. Using a 4 mm hex wrench, install the Fender Bracket.
See Figure 118 . Torque to 4.0 N-m (3.0 ft-lbf) .
NOTICE
Orient the Fender Bracket with the indent away
toward the rider platform.
8. Install the following components:
a. Rear Caliper & Rotor ( page 62 )
b. Rear Tire/Wheel ( page 30 )
c. Fender ( page 22 )
d. Bib Panel ( page 14 )
e. Storage Trays ( page 13 )
f. Battery Module ( page 8 )
9. Perform post-service tests ( page 127 ).
Figure 117: Caliper Bracket
Figure 118: Fender Bracket
23868-00001
28.5 N-m (21.0 ft-lbf)
Caliper Bracket
(23861-00001)
Fender Bracket
Left 24297-00001
Right 24298-00001
24270-00006
4.0 N-m (3.0 ft-lbf)
Drive Train