SE-3 Patroller
120
Rear Strobe Light Harness
This harness connects the PI Board to the rear strobe lights.
Tools Required:
Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (
page 8
)
b. Storage Trays (
page 13
)
c. Bib Panel (
page 14
)
d. Glove Box (
page 16
)
e. Front Cowl (
page 17
)
f. Light Cluster (
page 18
)
g. Right Side Panel (
page 20
)
h. Electronics Shield (
page 100
)
i.
Rider Detect Mat (
page 82
)
j.
Motor Cavity Lid (
page 89
)
3. Disconnect the wire harness from the PI Board.
See
Figure 166
.
4. Remove the two cable ties on the side of the frame.
5. Using a pair of wire cutters, remove the two cable ties
at the rear of the Motor Cavity.
6. Remove the Rear Strobe Light Harness.
Figure 166: Rear Strobe Light Harness to PI Board
Figure 167: Rear Strobe Light Harness to Lights
Rear Strobe
Lights
Harnesses
Summary of Contents for SE-3 Patroller
