Segway SE-3 Patroller, Service Manual

Page: 70 / 148

SE-3 Patroller
62
Rear Caliper & Rotor
Tools Required: 6 mm hex wrench
14 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module ( page 8 )
b. Storage Trays ( page 13 )
c. Bib Panel ( page 14 )
d. Fender ( page 22 )
e. Rear Tire/Wheel ( page 30 )
NOTICE
Leave the SE-3 jacked up.
3. Chock the wheels.
4. Release the rear brake.
5. Using a 6 mm hex wrench, remove the two caliper
fasteners. See Figure 88 .
6. Remove the Caliper and secure it so it doesn’t strain
the brake line.
7. Remove the Rotor and Spacer. See Figure 89 .
Place the rotor on a clean surface.
NOTICE
Scratching the Rotor or introducing debris could
shorten the life of the Rotor.
8. To remove the Caliper:
a. Drain the brake line ( page 53 ).
b. Using a 14 mm socket wrench, disconnect
the Banjo Bolt.
Figure 88: Rear Caliper
Figure 89: Rear Rotor
23868-00001
28.5 N-m (21.0 ft-lbf)
Rear Caliper
Right 23812-00001
Left 23810-00001
Spacer
24318-00001
Rear Rotor
23732-00001
Brakes