Segway SE-3 Patroller, Service Manual

Page: 126 / 148

SE-3 Patroller
118
Tail Light Harness
This harness connects the PI Board to the rear directional
lights and the brake lights. There are two separate harnesses,
one for each fender.
Tools Required: Wire cutters
4 mm hex wrench
10 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module ( page 8 )
b. Storage Trays ( page 13 )
c. Bib Panel ( page 14 )
d. Glove Box ( page 16 )
e. Front Cowl ( page 17 )
f. Light Cluster ( page 18 )
g. Side Panel ( page 20 )
NOTICE
Remove the left Side Panel to access the left
Tail Light Harness. Remove the right Side
Panel to access the right Tail Light Harness.
h. Electronics Shield ( page 100 )
3. Disconnect the wire harness from the PI Board.
See Figure 162 .
4. Using a pair of wire cutters, remove the two cable ties
on the side of the frame.
5. Using a 4 mm hex wrench, remove the fastener and
P-clip shown in Figure 163 .
6. Using a 10 mm socket wrench, remove the lock nut
and P-clip shown in Figure 164 .
7. Disconnect the wire harness from the tail lights.
See Figure 164 .
8. Remove the Tail Light Harness.
Figure 162: Tail Light Harness to PI Board
Figure 163: Tail Light Harness P-Clip
Left Right
Harnesses
P-Clip
(24509-00001)
24270-00004
5.5 N-m (4.0 ft-lbf)