Segway SE-3 Patroller, Service Manual

Page: 57 / 148

Service Manual
49
KeyLock
Tools Required: None
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module ( page 8 )
b. Storage Trays ( page 13 )
c. Bib Panel ( page 14 )
3. Press the tab on the side of the connector block
and pull it off the back side of the KeyLock. See
Figure 64 .
4. Unscrew the plastic nut on the back of the KeyLock.
See Figure 63 .
5. Remove the KeyLock.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Insert the KeyLock through the hole on the right hand
side of the Bib Panel. See Figure 63 .
3. Thread the plastic nut onto the back of the KeyLock.
Tighten finger tight, then turn an additional 1/8 turn.
4. Slide the connector block onto the back of the
KeyLock until it snaps in place.
5. Install the following components:
a. Bib Panel ( page 14 )
b. Storage Trays ( page 13 )
c. Battery Module ( page 8 )
6. Perform any post-service tests ( page 127 ).
Figure 63: KeyLock
KeyLock
(23969-00001)
Nut
Figure 64: KeyLock Closeup
Tab
Bib Panel Components