Segway SE-3 Patroller, Service Manual

Page: 37 / 148

Service Manual
29
23789-00001
67 N-m (49 ft-lbf)
Spindle
23768-00001
Front Tire/Wheel
23765-00001
Tire/Wheel Assemblies
Installation
1. Prepare the SE-3 Patroller by following the Setup
instructions ( page 28 ).
2. Slide the wheel onto the spindle. Orient the wheel so
the valve stem is away from the rotor.
See
Figure 34 .
3. Using the wheel nut key, install the four fasteners
attaching the wheel to the spindle.
Torque to
67 N-m (49 ft-lbf) .
4. Slide the wheel assembly onto the front fork. Orient
the Wheel assembly so the rotor is toward the left
side of the SE-3.
5. Slide the axle through the forks and wheel assembly.
See Figure 33 .
6. Using a pair of 30 mm socket wrenches, fasten the
nut onto the axle.
Torque to
85 N-m (63 ft-lbf) .
7. Using a bar clamp and socket, compress the caliper
as shown in Figure 31 , then remove the bar clamp.
8. Slide Caliper onto the Rotor so that the Rotor rests
between the two brake pads.
9. Using a 6 mm hex wrench, install the two fasteners
holding the Caliper in place. See Figure 32 .
Torque to 28.5 N-m (21 ft-lbf) .
10. Install the Front Fender ( page 24 ).
11. Perform post-service tests ( page 127 ).
24404-00001
85 N-m (63 ft-lbf)
Axle
(23773-00001)
Figure 33: Front Axle Removal
Figure 34: Front Wheel on Spindle