SE-3 Patroller
124
Siren Harness
This harness connects the PI Board to the Siren.
Tools Required:
Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (
page 8
)
b. Storage Trays (
page 13
)
c. Bib Panel (
page 14
)
d. Glove Box (
page 16
)
e. Front Cowl (
page 17
)
f. Light Cluster (
page 18
)
g. Right Side Panel (
page 20
)
h. Electronics Shield (
page 100
)
3. Disconnect the wire harness from the PI Board.
See
Figure 173
.
4. Using a pair of wire cutters, remove the two cable ties
on the side of the frame.
5. Disconnect the Siren Harness from the siren lead.
6. Remove the Siren Harness.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the Siren Harness to the siren lead.
3. Route the harness under the horizontal brace on the
frame. See
Figure 174
.
4. Connect the wire harness to the PI Board.
See
Figure 173
.
5. Install two cable ties around the harnesses on the
side of the frame.
6. Install the following components:
a. Electronics Shield (
page 100
)
b. Side Panel (
page 20
)
c. Light Cluster (
page 18
)
d. Front Cowl (
page 17
)
e. Glove Box (
page 16
)
f. Bib Panel (
page 14
)
g. Storage Trays (
page 13
)
h. Battery Module (
page 8
)
7. Perform post-service tests (
page 127
).
Siren
Figure 173: Siren Harness to PI Board
Harnesses
Figure 174: Siren Harness Routing
Brace
Summary of Contents for SE-3 Patroller
