Segway SE-3 Patroller, Service Manual

Page: 45 / 148

Service Manual
37
Front Strobe Light
Tools Required: 3 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Access the Light Cluster by following the instructions
to Remove Body Panels on page 36 .
3. Disconnect the wire harness.
4. Using a 3 mm hex wrench and a 7 mm socket wrench,
remove the two fasteners securing the light.
See
Figure 44 .
5. Remove the light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the wire harness through the hole in the Light
Cluster and connect it to the Front Light Harness.
See
Figure 45 .
3. Orient the light.
Police: Red toward center
Blue toward outside
Security: Locate the heat vent ( Figure 46 )
Right light = heat vent down
Left light = heat vent up.
4. Slide the plastic sleeves onto the fasteners, then
install the fasteners and lock nuts ( Figure 44 ).
5. Using a 3 mm hex wrench and a 7 mm socket wrench,
tighten the fasteners.
Torque to
1.6 N-m (1.2 ft-lbf) .
CAUTION!
Do not overtighten. Overtightening may damage the
rubber seal around the light.
6. Reassemble the SE-3 Patroller by following the
instructions to Install Body Panels on page 36 .
7. Perform post-service tests (
page 127
).
Figure 44: Front Stobe Lights
Front Strobe Light
Police 24252-00001
Security 24252-00002
24315-00006
23202-00001
1.6 N-m (1.2 ft-lbf)
Figure 45: Light Harnesses
Figure 46: Heat Vent Location
Heat Vent
Cap
Lights