SATO SG112 ex, Programming Reference Manual

Page: 325 / 516

324
[ESC+E] Auto Line Feed
ESC E Parameter Hexadecimal code
<1B>
16
<45>
16
aaa
Initial value None
When the power is OFF The set parameter is not maintained.
Valid range within items The set parameter becomes invalid.
Valid range and term of
command
Valid range between items The set parameter becomes invalid.
[Function]
Specifies amount of line spacing and CR (Line feed).
[Format]
<E>aaa
- Parameter
a [line spacing] = valid range : 0 to 999 dots
[Coding Example]
<A>
<E>10
<V>100<H>200<P>2<L>0304<XM>ABCDE+CR
FGHIJ+CR
<Q>2
<Z>
[Supplementary Explanation]
- When CR (0DH) is specified, linefeed based on line pitch will be performed.
- Rotation <%> can be used in combination with this command.
- This command may be used in a job and change the line spacing as necessary.
- Specify this command before designating the consecutive print of 1-line.
- Specifying font command executes the line feed regardless of CR/LF deletion setting.
- Performing auto linefeed by the designation of CR (0DH), print start position of linefeed will be
determined based on the pitch specified with Auto Line Feed <E> and the value specified with
Horizontal Print Position <H> designated after Auto Line Feed <E>. In case that Print Position
<H> is specified several times after Auto Line Feed <E>, return position by CR (0DH) will be at
the end of Print Position <H>.