Tel: 886.2.2175 2930 Email: [email protected]
www.salukitec.com
37
2
．
General-interface bus connector
As shown in Fig.3.22 this is a 24-pin D-type female connector, meeting the IEEE-488 standards. It is used to transmit and receive
GPIB/SCPI commands.
Fig. 3.22: General-interface Bus Connector
3
．
LAN connector
As shown in Fig. 3.23, this is a 10/100/1000BaseT Ethernet connector of standard 8-pin structure, and three data rates can be selected.
Fig. 3.23: LAN Connector
4
．
USB connector
As shown in Fig. 3.24, the connector jack is of Type A (four embedded contacts; with Contact 1 on the left side) and Type B. Type A
connector can be connected to the USB mouse, keyboard or other USB interface devices. The rear panel is equipped with four interfaces
in total.
Type B connector is mainly used for control. The network analyzer can be connected to the external computer or remote device through
SCPI control. The rear panel is equipped with one interface.
Fig. 3.24: USB Connector (B-type on the left and A-type on the right)
5
．
Video graphic adapter (VGA) output connector
As shown in Fig. 3.25, this is a 15-pin D-sub female connector to be connected with the external VGA display of corresponding resolution.
In this case, the user can observe the internal and external display at the same time.
