OPERATING INSTRUCTIONS
4618-021
65
Automatic tracking maximum span
This display is used to set the maximum amount that
the phase may change from its pre-set value.
Press the soft key adjacent to Maximum span to
change the maximum allowable change of phase.
Press the ENTER key when the correct maximum
span is showing
Automatic tracking damping
This number corresponds to how quickly the
automatic tracking will react to changes in phase and
sensitivity.
Press the soft key adjacent to Damping to change the
speed of response of the automatic tracking.
Press the ENTER key when the correct damping is
showing
NOTE
A low value for damping means a quick response - a
high value for damping means a slow tracking
response.
Summary of Contents for Signature
