TECHNICAL SPECIFICATION
6
4618 - 021
System Fault Relay (Optional
)
Volt-free changeover contacts that operate when the
Reject Confirmation Unit signals a reject fault.
Contact rating see
Reject Relay
.
Detect Signal
Operates on the detection of metal.
Output type
NPN open collector
Maximum voltage
35 Volts D.C.
Maximum current
100 mA
Fault/Detector Active Output
Output that operates if a fault occurs in the metal
detector or the detector is inactive.
Output type
NPN open collector
Maximum voltage
35 Volts D.C.
Maximum current
100 mA
Q.A. Due/Overdue Output
Output that operates when a performance test
becomes due or when a performance test becomes
overdue.
Output type
NPN open collector
Maximum voltage
35 Volts D.C.
Maximum current
100 mA
Pack Sensor Requirements
Operating voltage
15 Volts D.C.
Operating current
30 mA maximum
Output type
NPN or PNP open
collector (must be same as
Speed Sensor)
Speed Sensor Requirements
Operating voltage
15 Volts D.C.
Operating current
30 mA maximum
Output type
NPN or PNP open
collector (must be same as
Pack Sensor)
Output pulse width
10 ms minimum
Output frequency
50 Hz maximum
Reject Confirmation Sensor
Requirements
Operating voltage
15 Volts D.C.
Operating current
30 mA maximum
Output type
NPN or PNP open
collector
RS232 Serial Communications
Two communication ports COM1 and COM2 are
available from within the power unit enclosure.
Voltage levels as per RS232 standard, typically
± 9 volts.
Baud rate :
9600
Data bits :
1
Start bits :
1
Stop bits :
1
Parity bits :
1
Parity type
Odd
COM1 - 2 or 4 wire control for use with printer
(Hardware handshaking is only possible with 4 wire
control).
COM2 - 2 wire control for communications with
metal detector.
Summary of Contents for Signature
