Safeline Signature, Operating And Instruction Manual

Page: 39 / 168

OPERATING INSTRUCTIONS
4618 - 021 23
Product Number Settings Guide
Introduction
This guide should be performed for each product type that will be monitored by the detector.
The majority of products which have no product effect will operate on a single product number.
This guide sets all product-dependant settings of the detector.
NOTE
The ‘
Universal Settings Guide’
should be used
before this guide.
1)
‘Product Number and Automatic Setup’
on
page 43.
2)
‘Select and Update Timer’
on page 42.
3)
‘Inverse Detection’
on page 42.
4)
‘Automatic setup’
on page 50.
5)
‘Product Signal Cancellation’
on page 43.
6)
‘Automatic Tracking’
on page 45.
7) Go back to step 1) above for the next product to
be set up.
8)
‘Product Number and Automatic Setup’
on
page 40.
9)
‘Reject Inhibit’
on page 45.
NOTE
All of the following items may be set from the
Engineer Mode of operation.
Select the required product number to set up next.
Select the timer group for the product number.
If the product number is an inverse detect application
then select Inverse Detect.
Use the automatic facility of the detector to set the
phase and sensitivity.
If required then select the Product Signal Cancellation
feature.
If required then select the Automatic Tracking feature.
Finally change the product number to the product
number that is to be used next.
If this feature was enabled during the ‘Universal
Settings Guide’ then disable it after completing this
guide.