Safeline Signature, Operating And Instruction Manual

Page: 35 / 168

OPERATING INSTRUCTIONS
4618 - 021 19
Changing Numeric Values
Various settings in the program are stored as
numbers, eg product number, sensitivity, etc.
Numeric values can only be adjusted if a pointer is
visible on the LCD display adjacent to the parameter
to be adjusted and pointing toward the adjacent soft
key.
The display opposite shows two adjustable numeric
parameters, on the right of the display.
If a pointer is not visible the value of that parameter
cannot be changed in the current mode.
Note:
If the adjustable parameter is on the left side of the
display it will be indicated by a pointer, which will
change to a pointer when selected.
To change the numeric value of a particular setting
use the following procedure.
1) Enter security code, and press the ETC
softkey until the correct page is shown.
2) Press the soft key adjacent to the parameter 2 .
to be adjusted. The pointer will now point
inwards towards the parameter and a cursor bar
will appear under the first digit of the number.
3) Press the Up/Down keys 3 and adjust the digit
to the required value.
4) Press the cursor move key 4 to move the cursor
bar to the next digit.
5) Repeat step 3).
6) Repeat steps 3) and 4) for each digit to set the
required value.
7) Press the key to store the new value in
memory.