Safeline Signature, Operating And Instruction Manual

Page: 90 / 168

OPERATING INSTRUCTIONS
74 4618 - 021
QA OPERATOR MODE
Introduction
This mode is for carrying out a performance
check of the detector, and thus provide immediate
validation of the detector’s integrity.
The QA Inspector has the facility to set a timer in the
detector that will cause a ‘REQUEST FOR
PERFORMANCE CHECK’ message to appear at pre-
set intervals.
A QA Operator or the QA Inspector may perform
these tests to validate the detector at any time
however note that the test interval timer will be
restarted from 00:00 minutes as soon as a test has
been performed.
QA Operator Security Codes
All detectors are shipped from the factory with the
following security codes for QA Operators modes;
Code 1000 = QA Operator 1 Mode
Code 2000 = QA Operator 2 Mode
|
etc
|
Code 9000 = QA Operator 9 Mode
Carrying Out a Performance Check
Notes on the Test Sample
Always pass the test sample through the detector
aperture with the product.
If the detector is inspecting individual products
prepare a sample pack(s) with the sample(s) to be
tested placed at the centre rear of the pack(s).
Select Test Material
1) Press a soft key that is adjacent to the material of
your test sample.
The time that the next test will be requested is
displayed in the Running Mode. Please see the Time
section of the Running Mode for details.
A printout is automatically printed immediately a
performance check is carried out, providing the printer
option has been selected by the QA Inspector.
A sample of the performance check printouts is
provided in appendix C.