Saab 95 1967, Service Manual

Page: 380 / 610

3. Remove the clutch release levers from the clutch cover. , ~
4. Reduce slowly the pressure in the press.
5. Remove the clutch cover from the pressure plate. Loc
6. Remove the clutch springs.
ATION CF FAC'NG “NETS
Reassemble in the reverse order. having fitted new facings. the clutch disc should
er
8. Aft 55 check with the aid of a dial
be checked for skewne
indicator and an arbor.
INSTAL LATION
1. Insert the clutch disc, and refit the pressure plate as-
sembly in the flywheel.
2. Center the clutch disc with the arbor, tool 78 40 648,
which fits into the clutch disc bearing in the crank~
shaft end.
3. Tighten gradually the six retaining bolts of the clutch.
4. Install the engine, see section 201
CLUTCH DISC
Checking the clutch and changing disc facings
1. Examine the clutch face in the flywheel. Burns or
small scratches on the face are of minor importance.
If deep scores are present, on the other hand, the
flywheel should be machined or a new one fitted.
2. Check the pressure plate for scores or skewness. If the
surface Is uneven, fit a new pressure plate or alterna-
tively, face grind the worn face. .
3. Check the three clutch levers for wear These are Worn
by pressure against therelease plate. Whenchecking,
the latter must be removed. J’s: '1
Make sure that the release plateis ushemggedss,
Examine the relea é’tjearfng‘. f» .- =5; {é
Check
the clutch ar andMrefatfe?nec'l’és ry. ..
HE’S-"P
411-2 m