Saab 95 1967, Service Manual

Page: 231 / 610

STARTER
REMOVAL
1. Disconnect negative cable from battery.
2_ Disconnect supply cable from the solenoid switch.
3_ Disconnect positive cable from starter.
4, Unscrew the two retaining screws and remOVe starter
INSTALLATION
IMPORTANT
Before installing starter, check for wear on ring gear
and starter pinion. Clean all mating surfaces.
1.
Secure starter with the two retaining screws.
2. Connect cables to starter.
,
CABLE CONNECTIONS AND CABLE COLOURS, STARTER
1. Red from battery
2. 85 grey
3- 84 yellow
3. Connect negative battery cable.
“hr 1977
DISASSEMBLY
(See fig. overleaf)
992°:-
10.
11.
12.
13.
14.
Disconnect the solenoid feeder cable.
Remove the solenoid retaining screws.
Unhook and remove the solenoid.
Undo the two retaining screws from the capsule
bracket.
Remove the capsule bracket, U-washer, spacers and
rubber gasket (pos. 5—8). _
Undo the screws from the commutator bearing hous-
ing
Remove the commutator bearing housing
Lift the brush springs off their retainers with a wire
hook and remove the brushes.
Remove the brush plate, fiber washer and steel
washer (11—13).
Pull the starter assembly off the drive and bracket
assembly.
Undo the engaging lever arm locating screw.
Remove the rubber and steel washers from the drive
and bracket housing (17—18).
Remove the rotor and engaging lever arm.
Has the stop ring towards the cog with a piece of
tubing.
$1338
PRESSING DOWN THE STOP RING