Saab 95 1967, Service Manual

Page: 604 / 610

ToWHOOK ASSEMBLY
Saab 95
GENERAL
WEIGHT
COMPLETE: 16 kg (35 lb)
S 3601
TOWH 00K ASSEMBLY, SAAB 95
The tOWhook assembly for the Saab 95 is designed for a
maximum trailer weight of 910 kg (2000 lb).
To fit the towhook, proceed as follows:
1.
' CU" away the corrugated cardboard as b
Undo the four screws from the rear bumper mounts
in the legroom well of the extra seat. Remove the
rubber matting and mount the strut (2) with the bum-
per attachment screws. Cut away the corrugated card-
board so that the strut makes direct contact with the
deck plating.
Undo the screws that secure the bumper to the rear
mounts. Lift up the towhook (1) and secure it by the
rear mounting bar with the bumper retaining screws.
Chip away the underbody coating with a chisel or
similar so that the other attachment points of the
IOWhook make direct contact with the deck plating.
Drill four 8.5 mm (1/3”) holes through the deck plat-
("Q and strut using the towhook as a jig. Mount
the four M8 fasteners.
efore and
mount the angle iron (3) in the same way. Relay the
rubber matting.
5. After the towhook assembly has been approved by
the appropriate inspecting authority, coat any expo-
sed metal surfaces with fresh underbody sealing
compound.
A wiring assembly kit for 7-pole trailer connecting socket
can be bought as an accessory.
Install the wiring according to the wiring diagram and
instructions.
The assembly kit comprises the following components:
7-pole socket connector
Wiring harness
Screw
Nut
Spring washer
Cable shoe
Selft-tapping screw
m 9524