Saab 95 1967, Service Manual

Page: 151 / 610

MouNTING
POSITION OF THE CRANKSHAFT SEAL
12. Coat the two wedge-shaped seals with sealing com-
pound and press them into the rear main bearing
cap with a blunt screwdriver.
NOTE
The domed side of the seal must be turned to face
the main bearing cap.
INSTALLATION OF SEALING KEYS
13. Clean the crankshaft flange and the leWheeL In
late. Center the
the flywheel, using new bolts.
I4- Install the clutch disc and pressure p
disc with tool 78 40 648.
stall
15.
16.
17.
18.
Install
the oil pump. Tighten the actual pump bolts
first and then the suction line bolt.
Insert the rubber seal in the groove in the rear main
bearing cap.
Apply a coat of sealing compound to the two cor-
ner joints where the transmission cover, the inter-
mediate plate and the edges of the oil pan meet.
Position the oil pan gasket on the block, and in-
sert the two tabs on the cork gasket under the re-
cesses in the rear bearing cap rubber seal.
Install and secure the oil pan. Position the two
bolts with the rubber washers at the rear balance
shaft bearing.
POSITIONING OF BOLTS WITH RUBBER WASHERS
19. Put on the pulley and secure it with the bolt.
Replacement of crankshaft seal
(Engine removed)
1. Remove the clutch.
2. Remove the flywheel.
3. Remove the rear crankshaft seal by means of a screw-
driver.
4. Lubricate the inner diameter of the new crankshaft
seal with engine oil and push the seal onto the tool
78 62 170. Drive the seal onto the main bearing until
it has a distance of 0.36—0.38 in. (9.2—9.7 mm) from
the rear plane of the cylinder block.
5. Clean the crankshaft flange and the flywheel. Install
the flywheel, using new bolts.
6. Install the disc and the pressure plate. Center the disc
with tool 78 40 648.
21 6—3