Saab 95 1967, Service Manual

Page: 142 / 610

2 195. Place a support under the short
5 the flange onto the new shaft to the
n the figure. Do not refit the sealing
REPLACEMENT OF BALANCE SHAFT SEAL pump tool 78 6
shaft end and Pres
dimension shown I
Transmission cover removed
washer.
Drive out the seal, using tool 78 62 147.
7862”
57er
REMOVAL
OF SEAL, TRANSMISSION COVER
Tool 78 62147 REMOVAL OF FAN BEARING
Tool 78 62 436 and drift
Drive in the new seal in the transmission cover, using
tool 78 62 154, until it bottoms out.
m
INSTALLATION OF FAN BEARING
Tool 78 62196
INSTALLATION OF OIL SEAL, TRANSMISSION COVER
Tool 78 62 154
REPLACEMENT OF FAN BEARING
Transmission cover removed
To press out the fan bearing, use water pump tool
78 62 436 to hold up the transmission cover.
Press the bearing together with the shaft out from the
transmission cover with an arbor. The sealing washer on
engines up to No. 40 399 will be pressed out downwards
at the same time, and the flange will remain loose on the
transmission cover. Commence reassembly by pressing
the new shaft and bearing into the transmission cover.
Next, place the cover on the length of piping again and
press the new bearing in until it bottoms out, using water
IN STALLATION
POS|TION FOR FAN PULLEY FLANGE
215—2 Sun: