Saab 95 1967, Service Manual

Page: 134 / 610

rod ends in engine an arm "man the
heir original positions in the tappets,
ends of the rocker arms with engine
he oil return plate and rocker arm
6 Dip the 9”“
I- ' '
4. Apply sealing compound to the surfaces Of the cy push rodS m t
inder heads as indicated in the illustration 0" page 7 Lubricate the
210—10. Install the induction manifold gasket an OII and msta . .
make sure that the protruding part of the righthand assembIY- In so domg, align the push rods under
cylinder head gasket enters the apel’ture '" the m the rocker arms and ChECk tlve s rin Stum plate
duction manifold gasket. is not in Contact With t e va P 98- ecure the
rocker arm assembly by alternately tightening the
two screws.
8. Adjust the valve
justment". . ,
install the distributor in the engine block. (See
group 3, section 342.)
Insert a new gasket in the valve cover. Press the
f the gasket into the notches in the
play. See the section "Valve adv
clamp ends 0
cover.
I:
n
as
s
s
s
_‘
INSTALLATION OF INDUCTION MANIFOLD GASKET
5.
Fit the induction manifold. Tighten the screws and /
nuts with the tightening torque specified in group O. _ f.
51241
IMPORTANT
To ensure effective sealing, the bolts must be tight-
ened in two stages to the prescribed torque in the
sequence indicated.
INSERTION OF NEW GASKET IN VALVE COVER
NOTE
Before the valve covers of the cylinder heads are re-
fitted, the lubrication of the rocker shaft must be
checked with the engine running.
11.
Reinstall the carburetor, together with its gasket.
12. Reconnect the fuel and vacuum lines.
13. Reinstall the distributor cap and connect the igni‘
non cables.
14- Reinstall the alternator and its bracket. Tighten
the fan belt.
15. Install the air filter.
R NOTE
“mm” the cVlinder head bolts and adjust the
valves when the car has been driven for about
1,200 miles (2,000 km).
211—9